+86-532-86767619sales@gyrubber.cn

Categories

Guangyou Rubber Co. Ltd

Factory:Dawang Economic Area 

Office:  Qingdao Jinfu Mansion,22

Domestic Tel:     86-546-6897102

International Tel: 86-532-86767619

E-mail:  sales@gyrubber.cn

Web site:www.gyrubber.cn  


Home > News > Content

The Rubber Hose Is The Transmission Connection Pipe

Dongying Guangyou Rubber Co.,Ltd | Updated: Jun 07, 2017

The rubber hose is used for connection between two relatively moving parts. Installation of rubber hose should meet the following requirements: 1) to avoid sharp turns, the bending radius should be greater than the outer diameter of 9 ~ 10 times the bending distance from the joint should be at least six times the diameter of the rubber hose. Rubber Water Hose If the bending radius is only specified when the 1/2 can not be used, otherwise, life will be greatly reduced. 2) The bending of the hose with the hose connector should be installed on the same motion plane to prevent torsion. If the joints at both ends of the hose are to be moved on two different planes, the clamps should be fitted in the proper position and the hose divided into two parts so that each part moves in the same plane. 3) The hose should have a margin, since the length and diameter of the hose are increased (± 4% in length) when the hose is under pressure, so it can not be bent from the end fitting immediately after bending. When using in a straight line, do not stretch between the end fittings and the hose. Therefore, consider the length of the remaining margin, so that the hose is more relaxed. 4) Rubber Water Hose Hose in the installation and work, there should be no twisting phenomenon, should not be in contact with other pipelines, so as not to wear rupture. In the connection should be free to hang, so as to avoid bending due to their own weight. 5) because the hose at high temperatures working life is short, so as far as possible so that the hose installed away from the heat source, otherwise, to install the insulation board. 6) If the hose is too long or subjected to rapid vibration, Rubber Water Hose it is easy to hold the clip.

Rubber hose as a transmission medium connecting the pipeline, Rubber Water Hose in many industrial equipment has a daily life applications. In the car equipment is no exception.

In general, rubber hose is mainly used in the car ventilation system and cooling cycle system, such as: rubber hose is mainly connected to the engine and air filter, engine and radiator system, automotive air conditioning systems.

According to the use of conditions, Rubber Water Hose working pressure and structure of the different forms, can be made with a variety of fabrics, layers and the use of cloth hose. Without increasing the number of layers of the skeleton layer under the premise to increase the original size of the structure of the cloth hose pressure strength, the use of metal spiral in the outer layer of hose armored reinforcement, made of armored cloth hose.