+86-532-86767619sales@gyrubber.cn

Categories

Guangyou Rubber Co. Ltd

Factory:Dawang Economic Area 

Office:  Qingdao Jinfu Mansion,22

Domestic Tel:     86-546-6897102

International Tel: 86-532-86767619

E-mail:  sales@gyrubber.cn

Web site:www.gyrubber.cn  


Home > News > Content

Maintenance And Use Of Rubber Air Hose

Dongying Guangyou Rubber Co.,Ltd | Updated: Aug 18, 2017


Most of the rubber air hose has non-toxic, environmental protection, but some of the higher oil and gas pipes, in the rubber material added flame retardants, flame retardants containing toxic substances on the human body and the atmosphere will have a slight impact.

The characteristics of rubber hose, physiological inertia, UV-resistant, ozone-resistant, high and low temperature (* 80-300 degrees), high transparency, resilience, compression permanent deformation, oil resistance, stamping, acid, wear-resistant, nonflammable, voltage-resistant, conductive and other properties.

Maintenance and use of rubber air hose

Maintenance of rubber air hose after installation

1 correct use of rubber air hose

It is important to determine the length of the rubber tubing you need, Rubber Air Hose and also to check whether the rubber hose is in compliance with the requirements of the selected hose. Make sure that the rubber hose you will be using is the most appropriate. Work pressure and suction values should be carefully determined. In particular, Rubber Air Hose it should be noted that sudden pressure changes or peak pressure exceeding the maximum allowable value will significantly shorten the life of the rubber hose. The two ends of the rubber tube cannot continue to submerge in the conveying material.

2. Install rubber Hose for use

The life of the rubber hose is greatly shortened if you make the rubber hose less than the minimum required for the bending radius. Therefore, before installation, Rubber Air Hose it is recommended that you use information to consult, especially the rubber pipe bending radius information.

3. Maintenance of rubber air hose

Cleaning: After use, it is recommended that you clear the hose. Rubber Air Hose Should be cleaned if necessary. Check: The rubber hose must be inspected after each use to ensure that it does not have any structural damage. Pressure: Hydraulic testing is recommended if the rubber tube is subjected to severe pressure when used or if the outer layer of the rubber tube is exposed to the liquid transported for a long time.

Rubber Hose Storage Recommendations

Because of the natural nature of rubber, Rubber Air Hose the physical properties and performance of all rubber products will vary. These changes occur over time, usually depending on the type of rubber used. But it may also be accelerated by a combination of several factors or factors. Other materials used to reinforce the rubber hose may also be adversely affected by improper storage conditions. The following recommendations contain a range of precautionary measures to minimize the aging of objects in storage.

1. Rubber Air Hose Storage time

The rotation plan system should be used to shorten the storage time of rubber air hose as far as possible. If you are unable to avoid long storage and cannot comply with the following recommendations, Rubber Air Hose you should thoroughly check the rubber hose before use.

2. Rubber Air Hose Physical storage conditions

The storage of rubber air hoses must avoid mechanical pressure, including transition stretching, compaction or deformation, to avoid contact with sharp or sharp objects. Rubber Air Hose The rubber hose is preferentially stored on a suitable bracket or placed on dry ground. Coil packaging of rubber hose must be placed horizontally storage, rubber hose should not be stacked. If stacking is unavoidable, the stacking height should not cause permanent deformation of the rubber tube underneath. As a rule, try to avoid rubber tubes around columns or hooks. If the rubber hose is shipped in a straight tube, it is recommended to store horizontally without bending it.

3. Contact with other materials

Rubber air hoses shall not be exposed to solvents, fuels, oils, fats, unstable chemicals, acids, disinfectants, or general organic liquids. Furthermore, Rubber Air Hose any kind of rubber may be damaged after contact with certain materials or mixtures, including manganese, iron, copper and its alloys. Rubber tubing shall avoid contact with polyvinyl chloride (PVC) or wood or cloth impregnated with miscellaneous oil.

4. Temperature and humidity

Recommended storage temperature: 10 degrees Celsius to 25 degrees. Note: The rubber air hose shall not be stored at temperatures above 40 degrees Celsius or below 0 degrees Celsius. Special caution should be taken when moving rubber tubes below $number Celsius. The rubber hose shall not be stored in the heat source attachment, the relative humidity is not more than 65%.

5. Exposure to heat

The temperature limits described in 4th have to be complied with. If not, Rubber Air Hose the insulation should be used to protect the rubber hose from the heat source.

6. Exposure to light

Storage rooms for the storage of rubber air hoses should be kept dark, especially to avoid exposure to direct sunlight or strong artificial light to the rubber hose. Rubber Air Hose If the storage room has any openings that are covered by Windows or glass, it shall be shaded.

7. Exposure to oxygen and ozone

Rubber air hoses should be properly packaged or stored in airtight containers to avoid exposure to air. Storage rooms should not be equipped with easy release of ozone, Rubber Air Hose ozone for all rubber products have a particularly strong impact.

8. Exposure to electric or magnetic fields

Storage rooms should avoid any potential electrical or magnetic fields, including exposure to high-voltage cables or high-frequency generators.